How The RBG Remote Control Works

Once you've wired the lights. You're ready to use the remote. 

If you're unsure how to install the lights check out the video below:

SET button: Press it for two seconds to enter the setting mode and the RGB halo will be off as well.

Select one or more colors to set up the mode of FLASH, JUMP or FADE and it also has memory function.

The remote is set up as a two circuit design. The bottom buttons control the big bright light and the rest control the RGB halo. There are hidden controls on this remote.

When the big light is on you can dim it by holding the green – 

mode button on the cross pattern and raise the light using the + green mode button across from the –The RGB lights can also be dimmed by holding the Blue speed button at bottom of cross pattern then raise it by holding the upper blue speed button above.More about the functions can be found here.

Specifications